December 31, 2012

December 29, 2012

Fiddling with 3D


Lately I've been fiddling around with 3D programs, because I was fed up with the programs I was using that crashed too often which caused a lot of effort to be lost. This is very frustrating so after having the usual crashes in trueSpace, I changed to Hexagon which crashed less often, but enough to annoy the crap out of me. After visiting some friends who I hadn't seen for 8 or 10 years (...) I suddenly remembered that I had the same program - Cinema 4D - that one company I used to work for planned to throw away because they couldn't get it to work. I never gave it much attention until recently.

One of the first tinkerings with C4D - the EFC logo

December 7, 2012

Very fine and sharp dagger strokes


Here is a trick to take dagger stroking to the next level. Gravity feed airbrushes are particularly suited for this technique, since the paint cup is not in the way when you hold the airbrush at a very sharp angle relative to the surface. The risk of involuntary becomes larger however...., so a lid to close the paint cup would be handy. Or you can use a gun like the Iwata Custom Micron SB which is perfect for the job.


CM SB with paint cup mounted on the 'wrong' side

Inbetween project - Panther


With this portrait I try to see if it is possible to closely approach urethane paint airbrush quality with water-based paint, Holbein Aeroflash. Set-up is follows:
  1. Aeroflash thinned to 1 paint : 20 water : 3 drops of Talens Retarder
  2. Air pressure just high enough to push out the paint
  3. Airbrush CM SB with Aztek paint cup, polished needle. no air cap
  4. Dagger strokes while airbrush is at a very sharp angle relative to surface
  5. Hansa airbrush paper A4 size
  6. Projection method: lightbox that I described in an earlier blog entry
  7. 99% freehand (a little erasing here and there)
Newest image on top, older stages below.



Experiment failed



December 2, 2012

Make Iwata CM SB gravity feed


Testor's Aztek paint cups fit snugly onto the Iwata Custom Micron SB. It is easy to fit the siphon side cup on the Iwata which gives the benefits of a slightly larger volume and a lid that prevents unwanted paint spills plus an excellent balance since the Aztek's plastic side cups weight is next to nothing. It feels like mounting a Skoda wheel onto Ferrari, but for those who will stop at nothing, it works...


Aztek siphon paint cup on Iwata Custom Micron SB